PREV NEXT INDEX

Avici Systems Inc.

show mpls te lsdb addresses

Displays IP addresses of entries in the MPLS traffic engineering link state data base.

Syntax: show mpls te lsdb addresses

Description: Use the show mpls te lsdb addresses command to display the IP addresses of entries in the MPLS traffic engineering link state data base.

Factory Default: None.

Command Mode: Executive.

Example: The following example displays sample output of the show mpls te lsdb addresses command:

router#show mpls te lsdb addresses

Type Address C-Tunnel Tunnel-cost IGP-cost

link 3.3.3.1 - - -

link 3.3.3.2 - - -

link 4.4.4.1 - - -

link 4.4.4.2 - - -

router 10.254.5.1 - -   -

router 10.254.5.2 0x201c2a8 1 0

Table 1-13. Fields Displayed by show mpls te  lsdb addresses 
Field Description

Type

Indicates if the address is for a link or for a router.

Address

IP addresses of the links and routers.

C-Tunnel

Tunnel ID used to identify tunnels. This identifier is also used to identify tunnels in the output of the show mpls te lsdb route command.

Tunnel -cost

Cost from this LSR to the end (egress) of the tunnel.

IGP-costs

Cost from the tunnel endpoint (egress) to the destination address.

Related Commands: show mpls te
show mpls statistics
show mpls te tunnel

PREV NEXT INDEX

Copyright © 2004 Avici Systems Inc.
Avici® and TSR® is a registered trademark of Avici Systems Inc.
IPriori™, Composite Links™, SSR™, QSR, and NSR® are trademarks of Avici Systems Inc.

   Source File Name: TE%20Commands.fm
    HTML File Name: TE%20Commands78.html
    Last Updated: 12/19/04 at 14:56:07

Please email suggestions and comments to: doc@avici.com