show mpls rsvp

---

Displays general RSVP information.

Syntax: show mpls rsvp

Description: Use the show mpls rsvp command to display RSVP information.

Factory Default: None.

Command Mode: Executive and privileged.

Example: In the following example, The show mpls rsvp command displays general information about RSVP:

router#show mpls rsvp RSVP-TE is not enabled promiscuous mode is off number of explicitly configured neighbors: 0 number of MPLS enabled interfaces used by RSVP-TE: 0 default Path refresh: 30s, Resv refresh: 30s ingress midpoint egress merge number of current tunnels with installed labels: 0 0 0 - without installed labels: 0 0 0 - number of current LSPs with installed labels: 0 0 0 0 without installed labels: 0 0 0 0 average signaling traffic over last 60 seconds: incoming packets/sec: 0.000 kbits/s: 0.000 outgoing packets/sec: 0.000 kbits/s: 0.000 average signaling traffic over last 2 seconds: incoming packets/sec: 0.000 kbits/s: 0.000 outgoing packets/sec: 0.000 kbits/s: 0.000 router#

The following table describes the fields in the display:

Table 1-2. Fields Displayed by show mpls rsvp      

Field	Description
promiscuous mode	on = RSVP messages accepted from all addresses. off = RSVP messages accepted only from RSVP neighbors.
number of explicitly configured neighbors	Number of configured RSVP neighbors.
number of MPLS enabled interfaces used by RSVP-TE	Number of interfaces on the Avici router configured to support MPLS.
default Path refresh	Number of seconds between sending path refresh messages.
default Resv refresh:	Number of seconds between sending reservation refresh messages
number of current tunnels:
with installed labels:	Number of tunnels with LSPs in place.
without installed labels:	Number of tunnels where RSVP signalling is not yet complete.
number of current LSPs:
with installed labels:	Number of LSPs completely set up.
without installed labels:	Number of LSPs where RSVP signalling is not yet complete.
average signaling traffic over last 60 seconds:
incoming packets/sec.:	Number of incoming RSVP messages, shown as both packets per second and kilobits per second.
outgoing packets/sec.:	Number of outgoing RSVP messages, shown as both packets per second and kilobits per second.
average signaling traffic over last 2 seconds:
incoming packets/sec.:	Number of incoming RSVP messages, shown as both packets per second and kilobits per second.
outgoing packets/sec.:	Number of outgoing RSVP messages, shown as both packets per second and kilobits per second.

Related Commands: rsvp neighbor enable-label-requests
show mpls rsvp
show mpls rsvp lsp-list
show mpls rsvp neighbor
show mpls rsvp neighbor-list
show mpls rsvp statistics
show mpls rsvp tunnel

Copyright © 2004 Avici Systems Inc.
Avici® and TSR® is a registered trademark of Avici Systems Inc.
IPriori™, Composite Links™, SSR™, QSR, and NSR® are trademarks of Avici Systems Inc.

   Source File Name: TE%20Commands.fm
    HTML File Name: TE%20Commands67.html
    Last Updated: 12/19/04 at 14:56:07

Please email suggestions and comments to: doc@avici.com