| |
|
|
rsvp message-reliability
Enable sending message IDs in RSVP refresh messages.
Syntax: [no] message-reliability
Description: Refresh reduction message reliability is the replacing of RSVP-TE triggering message content with a message ID. Message IDs are not sent if a neighbor responds to a message ID with a PathError or ResvError message. Message IDs are not sent if the neighbor does not support refresh reduction. These behaviors assure compatibility with non-refresh reduction neighbors and standard RSVP-TE error conditions.
Use the rsvp message-reliability command to enable message reliability on this interface.
Use the no rsvp message-reliability command to disable message reliability on this interface.
Factory Default: Disabled.
Command Mode: Interface configuration.
Example 1: In the following example RSVP-TE message reliability is enabled on interface 1/1/1:
router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#interface pos 1/1/1
router(config-if)#rsvp message-reliability
router(config-if)#end
router#
Example 2: In the following example RSVP-TE message reliability is disabled on interface 1/1/1:
router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#interface pos 1/1/1
router(config-if)#no rsvp message-reliability
router(config-if)#end
router#
Related Commands: message-bundling
refresh-reduction
show mpls rsvp statistics
| |
|
|
Copyright © 2004
Avici Systems Inc.
Avici® and TSR®
is a registered trademark of Avici Systems Inc.
IPriori™, Composite Links™, SSR™, QSR, and NSR® are
trademarks of Avici Systems Inc.
Source
File Name: TE%20Commands.fm
HTML File Name: TE%20Commands62.html
Last Updated: 12/19/04 at 14:56:07