| |
|
|
mpls te tunnels
Enables/disables MPLS-CP on the interface.
Syntax: [no] mpls te tunnels
Description: MPLS-CP is a control protocol of PPP which enables use of MPLS on an interface on which MPLS is intended to be used. It must be enabled on each interface for MPLS to function properly. You enable MPLS-CP using the mpls te tunnels command in interface configuration mode.
To disable MPLS on an interface use the no option with this command..
Factory Default: Disabled.
Command Mode: Interface Configuration.
Example: In the following example MPLS-CP is enabled on interface 1/1/1:
router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#interface pos 1/1/1
router(config-if)#mpls te tunnels
router(config-if)#end
router#
Related Commands: mpls te
show mpls te
show mpls te interface
| |
|
|
Copyright © 2004
Avici Systems Inc.
Avici® and TSR®
is a registered trademark of Avici Systems Inc.
IPriori™, Composite Links™, SSR™, QSR, and NSR® are
trademarks of Avici Systems Inc.
Source
File Name: TE%20Commands.fm
HTML File Name: TE%20Commands42.html
Last Updated: 12/19/04 at 14:56:07