| |
|
|
ip flow-export destination
Configures the collector address to which Netflow packets are sent.
Syntax: [no] ip flow-export destination ip-address [udp-port] [version 5 {origin-as | peer-as}]
ip-address
Specifies the IP address of the collector to which Netflow packets are sent.
udp-port
UDP port to which Netflow packets are sent. Default: 2055.
Description: Configuration of a collector destination address specifies where Netflow packets are collected. The collector destination address is the IP address and UDP-port of the entity that collects the Netflow packets. Because there is not a default for this parameter, the collector destination address must be configured.
Use the ip flow-export destination command to configure the collector destination address. The Netflow version and the form of AS number the Netflow packet will use can also be specified by this command. AS number forms are Origin AS and Peer AS. Netflow version 5 is the supported version for this release.
The collector destination address can be configured both globally or per module. A module configuration over-rides a global configuration for the configured module.
Use the no ip flow-export destination command to set any collector destination addresses configured on modules to the global destination collector. Using this command at the global configuration command mode deletes the collector destination.
Factory Default: None.
Command Mode: Configuration for global affect and Module configuration for per module affect.
| |
|
|
Source
File Name: Routing_Pol.fm
HTML File Name: Routing_Pol13.html
Last Updated: 05/30/02 at 13:22:29
Please email suggestions and comments to: doc@avici.com