show crashdump

---

Displays crashdump configuration for specified platform.

Syntax: show crashdump {server serverID | module bay/slot | bay bay/slot}

serverID	Specifies the ID number of the route-controller. Valid Values: 1 - 64. Default: None
bay/slot	Specifies the bay and slot number of the module or bay-controller delineated by a forward-slash "/".

Description: Use the show crashdump command, specifying the platform, to display current crashdump configuration information.

Factory Default: None.

Command Mode: Executive and Privileged.

Example: The following example displays crashdump configuration for route-controller 1. .

router#configure terminal Enter configuration commands, one per line. End with CNTL/Z. router(config)#crashdump server 1 router(config)#exit router#show crashdump server 1 Crash dump settings: Exception from interrupt context - enabled Exception from task context - enabled Fatal call from interrupt context - enabled Fatal call from task context - enabled Panic call from interrupt context - enabled Panic call from task context - enabled host inet: inet on ethernet: 192.168.1.51 255.255.255.0 gateway inet: user: ftp password: (none) crashdump directory: retry: 0 sequence number: 0 filename: router#

The following table describes the fields in the display:

Table 3-18. show fabric links connectivity Field Descriptions

Field	Description
Exception from	Specifies whether exception event is enabled/disabled for each context.
Fatal from	Specifies whether fatal event is enabled/disabled for each context.
Panic from	Specifies whether panic event is enabled/disabled for each context.
host inet	Specifies the host IP address if any configured to receive the crashdump for this platform.
inet on ethernet	Specifies the local IP address that forwards that forwards the crashdump to the receive location.
gateway inet	Specifies the gateway, if any, that will be used for the transport of the crashdump to a remote host.
user	Specifies the configured FTP user name, if any, required for the FTP of the crashdump
ftp password	Specifies the FTP password, if any, required for the FTP of the crashdump
crashdump directory	Specifies the directory to receive the crashdump.
retry	Specifies the number of seconds to wait before attempting to resend the crashdump should communications not be available at the time of the failure.
sequence number	Specifies the beginning sequence number to be appended to the filename for multiple crashdumps.
filename	Specifies the filename to be used for this crashdump.

crashdump
crashdump force

Copyright © 2005 Avici Systems Inc.
Avici® and TSR® is a registered trademark of Avici Systems Inc.
IPriori™, Composite Links™, SSR™, QSR, and NSR® are trademarks of Avici Systems Inc.

   Source File Name: sys_mgmt.fm
    HTML File Name: sys_mgmt47.html
    Last Updated: 02/25/05 at 14:26:49

Please email suggestions and comments to: doc@avici.com