| |
|
|
primary-preference
Specifies the preference for this route controller being selected as primary or backup.
Syntax: primary-preference prefValue
prefValue
Specifies a numeric value indicating the preference of this server, relative to other servers, being selected primary. Default = 20.
Description: The route controller with the highest primary-preference value becomes primary upon system boot. Once the primary is selected, the backup is selected based upon an internal algorithm that takes into account its primary-preference value.
Use the primary-preference command in configuration command mode to set the primary preference value for this route controller.
Use the show server verbose command to display the primary preference value for this route controller.
Factory Default: 20.
Command Mode: Configuration.
Example: The following example sets the primary preference value for this route controller to 30:
router#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
router(config)#primary-preference 30
router(config)#end
router#show server verbose
Server ID 1
Server: upper - Controls slots 1 - 20
Location (bay/slot): 1/20
Server State: Primary
Primary server Id: 1
Backup server Id: none
Current Server Access Module: 1/17, on Eth1
Backup Server Access Module: 1/16, on Eth2
IPriori release version: x.x.xxx
Operational image version: Platform: xxxx; User: xxxxx; View: xxxxxxxx;
Unauthorized, unreleased image
Internal Avici use only, built Oct 3 2002, 15:47:03
ROM Version: IPriori Bootrom Release 6.3 built Sep 24 2002, 13:05:23
.
.
.
Primary Preference is: 30
Number of unplanned restarts: 0
router#
Related Commands: show server
| |
|
|
Copyright © 2005
Avici Systems Inc.
Avici® and TSR®
is a registered trademark of Avici Systems Inc.
IPriori™, Composite Links™, SSR™, QSR, and NSR® are
trademarks of Avici Systems Inc.
Source
File Name: sys_mgmt.fm
HTML File Name: sys_mgmt31.html
Last Updated: 02/25/05 at 14:26:49